Fiberglass resin


1. Function introduction FRP resin coating The machine is a fully automatic spraying machine integrating imported metering pump and imported spray gun. The degree of atomization is adjusted by controlling the atomization air pressure. The s

1. Function introduction FRP resin coating The machine is a fully automatic spraying machine integrating imported metering pump and imported spray gun. The degree of atomization is adjusted by controlling the atomization air pressure. The spraying machine is used to automatically and evenly spray the surface of the glass fiber reinforced plastic after precise proportioning and metering of the main agent and the curing agent. It completely replaces manual spraying, which greatly improves production efficiency and reduces production costs. At the same time, the equipment is equipped with an environmental protection device for concentrated absorption and treatment of waste gas generated by the injection of unsaturated resin, reducing production pollution. 2. Scope of application FRP resin spraying machine is suitable for industries such as engine room cover, auto parts, sanitary ware, industrial anti-corrosion, and waterproof engineering. 3. Applicable coating Unsaturated resin: viscosity below 10000mps ratio range: 100:1~100:3

Parameters

Unit

Main function

Longitudinal movement of the two-axis actuator (X-axis: horizontal movement of the glue head on the rail; Y-axis: manual adjustment of the up and down of the glue head); Built-in automatic glue application program (the glue track is customized by the manufacturer, and the workpiece margin can be Manual setting); Automatically clean the left and right workstations after the glue is sprayed; The glue storage barrel has automatic heating function;

Power source

Voltage 380V/220V, 50Hz.

Maximum glue output

8kg/min

Range of coating width

0~1250mm

Positioning accuracy

±5mm/10000mm

Low pressure foaming machine material tank Volume 30L
Automatic cleaning of the tank Volume 18L
Electronic control system Electric control system Independent control; automatic feeding system; with over-current, over-load, short-circuit, and lack of equal protection.
Service life Except for wearing parts, the design life of the equipment is ≥10 years.

Recommended